CPU, Power, Memory
Power Limit 3 Settings firmware setup page decoded from AMI HII/IFR resources.
Record 885
Enable/DisablePower Limit 3 override.
Enable/DisablePower Limit 3 override. If this option is disabled, BIOS will leave the hardware default values for Power Limit 3 and Power Limit 3 Time Window.
| Value | Label | Markers |
|---|---|---|
0 | Disabled | |
1 | Enabled |
| Store ID | Store label | Value | Option label |
|---|---|---|---|
0 | Standard | 0 | Disabled |
Record 886
Power Limit 3 in Milli Watts/Percent.
Power Limit 3 in Milli Watts/Percent. BIOS will round to the nearest 1/8W when programming. For example, if 12.50W, enter 12500, if 12%, enter 12000, if 50%, enter 50000. XE SKU: Any value can be programmed. Overclocking SKU: Value must be between Max and Min Power Limits (specified by PACKAGE_POWER_SKU_MSR). Other SKUs: This value must be between Min Power Limit and Processor Base Power (TDP) Limit. If the value is 0, BIOS leaves the hardware default value
| Store ID | Store label | Value | Option label |
|---|---|---|---|
0 | Standard | 0 |
Record 887
Power Limit 3 Time Window value in Milli seconds.
Power Limit 3 Time Window value in Milli seconds. The value may vary from 3 to 64(max).Indicates the time window over which Power Limit 3 value should be maintained. If the value is 0, BIOS leaves the hardware default value
| Value | Label | Markers |
|---|---|---|
0 | 0 | |
3 | 3 | |
4 | 4 | |
5 | 5 | |
6 | 6 | |
7 | 7 | |
8 | 8 | |
10 | 10 | |
12 | 12 | |
14 | 14 | |
16 | 16 | |
20 | 20 | |
24 | 24 | |
28 | 28 | |
32 | 32 | |
40 | 40 | |
48 | 48 | |
56 | 56 | |
64 | 64 |
| Store ID | Store label | Value | Option label |
|---|---|---|---|
0 | Standard | 0 | 0 |
Record 888
Specify the duty cycle in percentage that the CPU is required to maintain over the configured time window.
Specify the duty cycle in percentage that the CPU is required to maintain over the configured time window. Range is 0-100.
| Store ID | Store label | Value | Option label |
|---|---|---|---|
0 | Standard | 0 |
Record 889
Use Step Down Mode to adjust Psys_PL3 aggressiveness.
Use Step Down Mode to adjust Psys_PL3 aggressiveness. Battery-enabled systems use Standard mode
| Value | Label | Markers |
|---|---|---|
0 | Aggressive | Standard defaultManufacturing default |
1 | Standard |
| Store ID | Store label | Value | Option label |
|---|---|---|---|
0 | Standard | 0 | Aggressive |
Record 890
Power Limit 3 MSR 615h Lock.
Power Limit 3 MSR 615h Lock. When enabled PL3 configurations are locked during OS. When disabled PL3 configuration can be changed during OS.
| Value | Label | Markers |
|---|---|---|
0 | Disabled | |
1 | Enabled |
| Store ID | Store label | Value | Option label |
|---|---|---|---|
0 | Standard | 0 | Disabled |